2008 Lincoln Mark LT Owner Guide 3rd Printing - Page 101
2008 Lincoln Mark LT Manual
Page 101 highlights
Driver Controls • Continue to press and hold the HomeLink button (note Step 2 in the Programming section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink. The indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. • Proceed with Step 3 in the Programming section. Operating the HomeLinkா Wireless Control System To operate, simply press and release the appropriate HomeLink button. Activation will now occur for the trained product (garage door, gate operator, security system, entry door lock, or home or office lighting etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties, contact HomeLink at www.homelink.com or 1-800-355-3515. Erasing HomeLinkா buttons To erase the three programmed buttons (individual buttons cannot be erased): • Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with Step 1 in the Programming section. Reprogramming a single HomeLinkா button To program a device to HomeLink using a HomeLink button previously trained, follow these steps: 1. Press and hold the desired HomeLink button. Do NOT release the button. 101 2008 Mark LT (mlt) Owners Guide (post-2002-fmt) USA (fus)