2008 Lincoln Mark LT Owner Guide 3rd Printing - Page 121

Locks and Security • you shift into any gear putting the vehicle in motion, and • the brake pedal is released and the vehicle attains a speed greater than 5 mph (8 km/h). The autolock feature repeats when: • any door is opened then closed while the ignition is in the 3 (ON) position, and • the brake pedal is released and the vehicle attains a speed greater than 5 mph (8 km/h). Deactivating/activating autolock Your vehicle comes with the autolock feature activated. There are four methods to enable/disable this feature: One is through your authorized dealer, the second with a power door unlock/lock sequence, the third with the keypad, and the fourth using the message center. Before following the activation or deactivation procedures, unlock all doors using the power door lock/unlock control and ensure all vehicle doors are closed. Power door unlock/lock procedure You must complete Steps 1-5 within 30 seconds, or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait a minimum of 30 seconds to begin again. 1. Turn the ignition to the 3 (ON) position, then press the control three times. 2. Turn the ignition to the 1 (OFF/LOCK) position, then press the control three times. 3. Turn the ignition to the 3 (ON) position; the horn will chirp to indicate the driver configuration mode has been activated. then the control. Note: One horn 4. Within five seconds, press chirp should be heard, indicating the system has been disabled. Conversely, a horn chirp followed by a honk will indicate the system is control then the control will turn the enabled. Pressing the feature ON if it was previously OFF, or OFF if it was previously ON. The horn will chirp once if autolock was deactivated or twice (one short chirp and one long honk) if autolock was activated. 121 2008 Mark LT (mlt) Owners Guide (post-2002-fmt) USA (fus)