2002 Mercedes C-Class Owner's Manual - Page 232
2002 Mercedes C-Class Manual
Page 232 highlights
3. Firmly press and release the programmed integrated remote control transmit button. Press and release same button a second time to complete the training process. (Some garage door openers may required you to do this procedure a third time to complete the training.) 4. Confirm the garage door operation by pressing the programmed button on the integrated remote control transmitter. Canadian programming: During programming, your hand-held transmitter may automatically stop transmitting. Continue to press and hold the integrated remote control transmitter button (note steps 2 through 4 in the "Programming" portion) while you press and re-press ("cycle") your hand-held transmitter every two seconds until the frequency signal has been learned. The indicator lamp will flash slowly and then rapidly after several seconds upon successful training. Operation of remote control: 1. Turn electronic key in starter switch to position 1 or 2. 2. Select and press the appropriate button to activate the remote control device. The integrated remote control transmitter continues to send the signal as long as the button is pressed - up to 20 seconds. Erasing the remote control memory: 1. Turn electronic key in starter switch to position 1 or 2. 2. Simultaneously holding down the left and right side buttons for approximately 20 seconds, or until the control lamp blink rapidly, will erase the codes of all three channels. Garage door opener Instruments and controls Operation Driving 229 Instrument cluster display Practical hints Car care Technical data Index