2003 Mercedes ML-Class Owner's Manual - Page 256

Practical hints Flat tire Warning! G The jack is designed exclusively for jacking up the vehicle at the jack take-up brackets built into both sides of the vehicle. To help avoid personal injury, use the jack only to lift the vehicle during a wheel change. Never get beneath the vehicle while it is supported by the jack. Keep hands and feet away from the area under the lifted vehicle. Always firmly set parking brake and block wheels before raising vehicle with jack. Do not disengage parking brake while the vehicle is raised. Be certain that the jack is always vertical (plumb line) when in use, especially on hills. Always try to use the jack on level surface. Make sure that the jack arm is fully seated in the jack take-up bracket. Always lower the vehicle onto sufficient capacity jackstands before working under the vehicle. On wheel to be changed, loosen but do not yet remove the wheel bolts (approximately one full turn with wrench). The jack take-up brackets are located directly behind the front wheel housings and in front of the rear wheel housings. 1 Take-up bracket 2 Jack Place jack on firm ground. Position jack 2 under the take-up bracket 1 so that it is always vertical (plumb-line) as seen from the side, even if the vehicle is parked on an incline. Jack up the vehicle until the wheel is a maximum of 1.2 in (3 cm) from the ground. Never start engine while vehicle is raised. ! Do not position the jack on the body of the vehicle, as this may cause damage to the vehicle. 256