2006 Mercedes CLK-Class Owner's Manual - Page 324

Operation Engine compartment Checking engine oil level with the control system When checking the oil level the vehicle must be parked on level ground with the engine at operating temperature, the vehicle must have been stationary for at least 5 minutes with the engine turned off with the engine not at operating temperature yet, the vehicle must have been stationary for at least 30 minutes with the engine turned off To check the engine oil level via the multifunction display, do the following: Switch on the ignition ( page 34). The standard display ( page 144) should appear in the multifunction display. Press buttonk or j on the multifunction steering wheel until the following message is seen in the multifunction display: One of the following messages will subsequently appear in the multifunction display: Engine oil level ok Add 1.0 qt. to reach max. oil level i If you want to interrupt the checking procedure, press the k or j button on the multifunction steering wheel. If necessary, add engine oil. For adding engine oil, see ( page 325). For more information on engine oil, see the "Technical data" section ( page 479) and ( page 481). Other display messages If the SmartKey is not turned to position 2 in the starter switch, the following message will appear: Turn on ignition to see engine oil level (Canada: 1.0 liter) Add 1.5 qt. to reach max. oil level (Canada: 1.5 liter) Add 2.0 qt. to reach max. oil level Switch on the ignition ( page 36). (Canada: 2.0 liter) 323