2007 Mercedes C-Class Owner's Manual - Page 223

Controls in detail Power windows Opening the windows Press switch 1 to 4 to the resistance point. The corresponding window will move downwards until you release the switch. Closing the windows Pull switch 1 to 4 to the resistance point. The corresponding window will move upwards until you release the switch. Warning! Fully opening the windows (Express-open) Press switch 1 to 4 past the resistance point and release. The corresponding window opens completely. Fully closing the windows (Express-close) Pull switch 1 to 4 past the resistance point and release. The corresponding window closes completely. Warning! G Driver's door only: If within 5 seconds you again pull the switch past the resistance point and release, the automatic reversal will not function. Stopping windows Press or pull respective switch again. Synchronizing power windows The power windows must be resynchronized each time after the battery has been disconnected or discharged. if the power windows cannot be fully opened (Express-open) or closed (Express-close). Switch on the ignition ( page 32). G If you pull and hold the switch up when closing the window, and upward movement of the window is blocked by some obstruction including but not limited to arms, hands, fingers, etc., the automatic reversal will not operate. ! If the upward movement of the window is blocked during the closing procedure, the window will stop and open slightly. Remove the obstruction, pull the switch again past the resistance point and release. If the window still does not close when there is no obstruction, then pull and hold the switch again. The side window will then close without the obstruction sensor function. 222