2007 Mercedes C-Class Owner's Manual - Page 358

Practical hints Where will I find ...? Storing the vehicle tool kit Place vehicle tool kit 6 in vehicle tool kit storage well casing 5. Place storage well casing 2 over the vehicle tool kit storage well casing 5 and turn retaining screw 1 clockwise as far it will go to secure the Minispare wheel. 3 Arrow 4 Minispare wheel with spare wheel bolts in container on wheel rim 5 Vehicle tool kit storage well casing 6 Vehicle tool kit Remove vehicle tool kit 6. Vehicle jack Warning! G i Arrow 3 on vehicle tool kit storage well casing 5 must point in the direction of travel. Otherwise you cannot place the storage well casing 2 on top and secure the Minispare wheel with retaining screw 1. The jack is designed exclusively for jacking up the vehicle at the jack take-up brackets built into both sides of the vehicle. To help avoid personal injury, use the jack only to lift the vehicle during a wheel change. Never get beneath the vehicle while it is supported by the jack. Keep hands and feet away from the area under the lifted vehicle. Always firmly set parking brake and block wheels before raising vehicle with jack. Do not disengage parking brake while the vehicle is raised. Be certain that the jack is always vertical (plumb line) when in use, especially on hills. Always try to use the jack on level surface. Make sure the jack arm is fully seated in the jack take-up bracket. Always lower the vehicle onto sufficient capacity jackstands before working under the vehicle. ! To prevent damage, always disengage trunk floor handle from upper edge of trunk and lower trunk floor before closing the trunk. 357