2007 Mercedes G-Class Owner's Manual - Page 376

Practical hints Brush guard Brush guard The brush guard is available on G 55 AMG (U.S vehicles only). To help prevent personal injury when opening or closing the brush guard, use extreme caution not to trap hands or feet. The brush guard must be in raised and locked position while driving. Lowering While holding brush guard firmly, open quick lock 2 using locking and unlocking handle 1. Gently lower brush guard until it reaches its fully lowered position. Raising and securing Flip up brush guard until it contacts end stop joint 4. Quick lock stop pin 2 must engage the cross slot recess in lock 3. Now turn quick lock 2 so that quick lock makes contact with end stop joint 4. Lock quick lock 2 on both sides of brush guard using locking and unlocking handle 1. i Only lower brush guard to clean headlamps or to replace bulbs. Lowering and raising brush guard Warning! G The brush guard is designed solely to enhance the appearance of the vehicle and help protect grille and headlights from minor mishaps, either on- or off-road. Since the safety characteristics are limited in the event of an accident, brush guards are not intended to prevent injury or damage in the event of an accident. Also check state and local regulations on installation and use. Raise and lower brush guard in an open space with plenty of room. 1 Locking and unlocking handle 2 Quick lock 3 Lock 4 End stop joint ! Make sure both quick stop pins 2 are seated fully in lock 3. 375