1997 Mercury Villager Owner Guide 1st Printing - Page 119

Controls and Features THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Replacement/Additional Transmitters In the event a transmitter is lost or an additional remote transmitter needs to be set, you must change the ID code. Follow the steps below to change the ID code of your system, or return the remaining transmitter(s) to your dealer for reprogramming of your remote entry system. This is necessary to prevent unauthorized use of the lost transmitter. ID Code Programming Procedure NOTE: All transmitters must be programmed (or reprogrammed) at the same time. If the programming mode is entered and the transmitters are not programmed (or reprogrammed) at the same time, they will not operate with the system. 1. Enter vehicle and close and lock all doors. 2. Insert and remove key from ignition six times within ten (10) seconds. The instrument panel lights will flash twice. 3. Turn ignition key to the ACC position. 4. Press the LOCK button on the remote transmitter once. 5. To enter additional remote controllers (including the original), unlock, then lock the driver's door using the power door lock switch. 117