1997 Nissan Pickup Owner's Manual - Page 17

HEADLIGHT AND TURN SIGNAL SWITCH CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system, which may affect your warranty coverage. Some conditions may cause the malfunction indicator light to come on steady or blink. Examples are as follows: ● vehicle ran out of fuel, which caused the engine to misfire. ● fuel filler cap was left off or improperly installed, allowing fuel to evaporate into the atmosphere. If you suspect that you experienced one or both of the above conditions, drive the vehicle to an authorized NISSAN dealer and have the vehicle inspected. Avoid any unnecessary diagnosis during the service by informing the dealer of the conditions listed above that may have cccurred. AIC0739 Lighting Turn the switch to the position: The side marker, tail, license plate and instrument lights come on. position: Turn the switch to the The headlights come on and all the other lights remain on. To select the high beam function, push the lever forward. The high beam lights come on and the indicator light illuminates. Pull it back to select the low beam. DAYTIME RUNNING LIGHT SYSTEM (Canada only) The headlights automatically illuminate at a reduced intensity when the engine is started with the parking brake released. The daytime running lights operate with the headlight switch in the OFF position or in the position. Turn the headlight switch to the position for full illumination when driving at night. If the parking brake is applied before the engine is started, the daytime running lights do not illuminate. The daytime running lights illuminate once the parking brake is released. The daytime run- 1-10