2002 Nissan Quest Owner's Manual - Page 126
2002 Nissan Quest Manual
Page 126 highlights
5. Press the desired button until the red indicator light flashes slowly. Do not release the button. Continue holding and press the hand-held transmitter button through step 6. 6. Hold down both buttons until the red indicator light on the HomeLinkா Universal Transceiver flashes rapidly (This may take 1 to 90 seconds). Then release both buttons. The rapid flashing means that the transceiver has been successfully programmed to match your hand-held transmitter. You can now use the HomeLinkா Universal Transceiver instead of your hand-held transmitter. cating a successful programming procedure. If it returns to the slow blink of program mode, continue to periodically reactivate your hand-held transmitter until a successful programming procedure is indicated by the rapidly flashing indicator light. ● Hold buttons for duration of the programming without interruption. ● Rotate your hand-held transmitter endover-end and program again. For best results, place the end opposite the battery compartment against the HomeLinkா Universal Transceiver when programming. OPERATING THE HomeLinkா UNIVERSAL TRANSCEIVER To operate, simply press the appropriate button on the HomeLinkா Universal Transceiver. The red indicator light illuminates while the signal is being transmitted. The effective transmission range of the HomeLinkா Universal Transceiver may differ from your hand-held transmitter. PROGRAMMING Homelinkா FOR CANADIAN CUSTOMERS Prior to 1992, D.O.C. regulations required many hand-held transmitters to stop transmitting after one or two seconds, even though you continue to hold down the button. If you think you have one of these hand-held transmitters, you should press and re-press the transmitter button every 2 seconds without ever releasing the HomeLinkா Universal Transceiver button. The indicator light on the HomeLinkா Universal Transceiver should blink rapidly indi- PROGRAMMING TROUBLE DIAGNOSIS Be sure to keep your original hand-held transmitter for possible reprogramming if necessary. ● Make sure batteries in the hand-held transmitter are fully charged. ● Hold your hand-held transmitter against the bottom surface of the HomeLinkா Universal Transceiver so that you can still see the red indicator light. Instruments and controls 2-37