2002 Nissan Quest Owner's Manual - Page 164

window. When the indicator bar is in the center position the sound is equally distributed between the right and left speakers. Following balance adjustment, the display window shows the current setting for three seconds, then returns to the display prior to adjustment. Fader Fader control allows you to adjust sound distribution between the front and rear speakers. Push the FADE button and the setting indicator bar appears in the display window. Press the SELECT button to shift the sound to the front speakers. The single indicator bar moves to the right of the display window. Press the SELECT button to shift the sound to the rear speakers. The single indicator bar moves to the left of the display window. When the indicator bar is in the center position the sound is equally distributed between the front and rear speakers. Following fader adjustment, the display window shows the current setting for three seconds, then returns to the display prior to adjustment. COMP button Press this button to activate the compression function. This reduces the dynamic range, which provides the listener with a more consistent level of volume. The display window shows a C when the COMP button is pushed. Clock operation The clock is on in the display regardless of what mode, media, or function the radio is in as long as the ignition is in ACC or ON. Clock set Press the RDS/CLK button until SELECT HOURS is displayed then use the SEL buttons to change the hour, press the RDS/CLK button again until SELECT MINS is displayed then use the SEL buttons to change the minutes. The display will return to clock priority mode in 10 seconds or press the RDS/CLK button to return to the clock display. Selecting the desired band Push the AM or FM buttons to change to AM or FM band reception. The FM stereo indicator, ST illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. FM-AM radio operation MUTE button Push the MUTE button to mute out the radio. TUNE buttons WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. Use the or buttons for manual tuning. To move quickly through the channels, hold either of the tune buttons down for more than 0.5 seconds. AUTO SET Press the AUTO button while listening to the radio to activate the auto set feature. When AUTO is depressed for less than 5 seconds, the display window momentarily indicates AUTO ON, and the radio seeks the first six strong stations for the respective band. The first six strong stations are then stored in order in memory buttons one through six. Heater, air conditioner and audio systems 4-21