2002 Nissan Quest Owner's Manual - Page 86
2002 Nissan Quest Manual
Page 86 highlights
shoulder harness retractor is in the emergency locking mode. WARNING The automatic locking mode (child restraint mode) must be reactivated each time you place a child in the integrated child safety seats. In addition to the automatic locking retractors, the integrated child safety seat shoulder harnesses are equipped with emergency locking retractors. The automatic locking mode is best to use, especially for children who need help staying properly positioned in the seat and its harnesses (for example, children who are younger and smaller), because the belts are always locked. In the emergency locking mode, the shoulder belts only lock in a sudden stop or accident, allowing a child more freedom of movement. Use the emergency locking mode only if you judge your child able to remain properly positioned in the integrated child safety seat. ness tongues from the belt buckle by pressing the red belt buckle button. 3. Move the left and right shoulder harnesses aside and assist the child from the integrated child safety seat. Integrated Child Safety Seat maintenance ● To clean the shoulder harnesses and belt buckle webbing, apply a mild soap solution or any solution recommended for cleaning upholstery or carpets. Then brush the webbing, wipe it with a cloth and allow it to dry in the shade. Do not allow the shoulder harnesses to retract until they are completely dry. ● The integrated child safety seats cloth removable pads may be cleaned with mild soap and water. The cloth removable pads are attached to the seats with fastener strips, and may be easily removed. The pads are machine washable. Fo best results, machine wash in cold water in the gentle cycle. Tumble dry on low heat. Do not use chlorine bleach, and do not dry clean. CAUTION Failure to follow the washing instructions provided on the cloth removable pads may result in premature wear or damage. Storing the Integrated Child Safety Seat 1. Be sure the shoulder harnesses are fully retracted and resting inside the integrated child safety seat recess. It is not necessary to reconnect the shoulder harnesses and belt buckle prior to storing the integrated child safety seat. 2. While holding onto, but not pulling, the cushion release strap, rotate the cushion upward until it fits flush with the second row seat back cushion and locks into position. 3. Be sure the integrated child safety seat is locked in the stowed position by grasping the safety seat cushion and attempting to lower it without pulling the cushion release strap. If the integrated child safety seat is not locked in the stowed position, repeat steps one through three. Removing the child 1. Release the chest clip. 2. Release the left and right shoulder har- Seats, restraints and supplemental air bag systems 1-79