2002 Nissan Quest Owner's Manual - Page 127

ROLLING CODE PROGRAMMING If your hand held transmitter appears to train to the HomeLinkா Universal Transceiver, but does not open your garage door, and your garage door opener was manufactured after 1995, your garage door opener may have a Code Protected or Rolling Code feature. This type of system will change the code of your garage door opener every time you open or close your garage door. To determine if you have one of these systems, depress the button on the HomeLinkா Universal Transceiver that you have just programmed. If the LED on the HomeLinkா Universal Transceiver flashes rapidly for 1 to 2 seconds, then remains on, your garage door opener has a rolling code system. To operate your rolling code garage door opener from your HomeLinkா Universal Transceiver, follow these steps: 1. Program your hand held transmitter to the HomeLinkா Universal Transceiver by following the procedures outlined previously (if not yet programmed). 2. Program your garage door opener receiver to recognize the HomeLinkா Uni- versal Transceiver (The HomeLinkா Universal Transceiver follows the same procedure to train to the receiver as your hand held transmitter did when it was first installed): a) Remove the cover panel from your garage door opener receiver. The receiver should be located by the garage door opener motor. b) Locate the training button on the garage door opener receiver. The exact location and color of the button may vary by garage door opener brand. If you have difficulty locating the training button, reference your garage door opener manual. If you have difficulty programming your garage door opener equipped with a rolling code system to recognize the HomeLinkா Universal Transceiver with the Rolling Code feature, call NISSAN Consumer Affairs Department. c) Press the training button on the garage door opener receiver for 1 to 2 seconds. AIC1070 CLEARING THE PROGRAMMED INFORMATION Should you sell your vehicle, be sure to clear the channels of the HomeLinkா Universal Transceiver. To clear the channels, simultaneously hold down the outside two buttons (#1 & #3) until the red indicator light begins to flash rapidly (approximately 20 seconds). This will clear all three buttons. Individual buttons cannot be cleared, but can be reprogrammed at any time by following the programming procedures described previously. 2-38 Instruments and controls