2003 Nissan Altima Owner's Manual - Page 129

When no CD is loaded, the radio comes on. Pushing the PWR/VOL control knob again turns the system off. Turn the PWR/VOL control knob to the right to increase volume or to the left to decrease volume. Adjusting tone quality and speaker balance Press the AUDIO button to enter the audio adjust mode: Bass→Treb→Fade→Bal Press the TUNE/FF-REV ( SEEK/TRACK ( or or ) or ) to adjust to the 2. The hours will start TUNE/FF-REV ( SEEK/TRACK ( the hours. or flashing. Press or ) or ) to adjust TUNE/FF-REV WARNING The radio should not be tuned while driving so full attention may be given to vehicle operation. Use the and buttons for manual tuning. To move quickly through the channels, hold the tuning buttons down. SEEK tuning Push SEEK/TRACK ( or ). SEEK tuning begins from low to high frequencies or high to low frequencies, depending on which button is pressed, and stops at the next broadcasting station. If using the up button, once the highest broadcasting station is reached, the radio continues in the SEEK mode at the lowest broadcasting station. If using the down button, once the lowest broadcasting station is reached, the radio continues in the SEEK mode at the highest broadcasting station. SCAN tuning Push the SCAN button. SCAN illuminates in the display window. SCAN tuning begins from low to high frequencies or high to low frequencies. SCAN tuning stops for 5 seconds at each broadcasting station that has sufficient signal strength. 3. Press the MENU button to switch to the minute adjustment. 4. Press TUNE/FF-REV ( SEEK/TRACK ( the minutes. 5. Press the MENU button again to exit the clock set mode. The display will return to the regular clock display after 7 seconds, or you may press the MENU button again to return to the regular clock display. or or ) or ) to adjust desired levels. The display will return to the regular radio display after 7 seconds, or you may press the AUDIO button again to return to the regular radio display. Clock operation Pressing the MENU button displays the clock with the radio on or off. Press the MENU button again to turn off the clock display. Clock set 1. Press and hold the MENU button until it beeps (>2 seconds). FM-AM radio operation FM-AM band select Push the AM or the FM button to change from AM to FM reception. The FM stereo indicator, ST, illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automatically changes from stereo to monaural reception. Heater, air conditioner and audio systems 4-21