2011 Nissan cube Owner's Manual - Page 205
2011 Nissan cube Manual
Page 205 highlights
surrounded by metal or far away from the invehicle phone module to prevent tone quality degradation and wireless connection disruption. . While a cellular phone is connected through the Bluetooth® wireless connection, the battery power of the cellular phone may discharge quicker than usual. The Bluetooth® Hands-Free Phone System cannot charge cellular phones. If the Bluetooth® Hands-Free Phone System seems to be malfunctioning, see "Troubleshooting guide" later in this section. You can also visit www.nissanusa.com/bluetooth for troubleshooting help. Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise. Refer to the cellular phone Owner's Manual regarding battery charging, cellular phone antenna, etc. * * * Modulation: FHSS GFSK 8DPSK, p / 4DQPSK Number of channels: 79 This wireless equipment cannot be used for any services related to life safety because there is the possibility of radio interference. IC Regulatory information - Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. - This Class B digital apparatus meets all requirements of the Canadian InterferenceCausing Equipment Regulations. REGULATORY INFORMATION Bluetooth trademark: Bluetooth® is a trademark owned by Bluetooth SIG, Inc., U.S.A. and licensed to Visteon Corporation. . USING THE SYSTEM The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth® HandsFree Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. . FCC Regulatory information - CAUTION: To maintain compliance with FCC's RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. - Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device Initialization When the ignition switch is pushed to the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. If the button is pushed before the initialization completes, the system will not accept any command. . This wireless hands-free car kit is based on Bluetooth technology. * * Frequency: 2402 MHz - 2480 MHz Output power: 4.14 dBm E.I.R.P Operating tips To get the best performance out of the NISSAN Voice Recognition system, observe the following: Heater, air conditioner, audio and phone systems 4-57