2011 Nissan cube Owner's Manual - Page 38
2011 Nissan cube Manual
Page 38 highlights
Stowing rear center seat belt: When folding down the rear seat, the rear center seat belt can be retracted into a stowed position as follows: 1 so that the 1. Hold the connector tongue * seat belt does not retract suddenly when the tongue is released from the connector 1 buckle. Release the connector tongue * 2 by inserting a suitable tool such as key * into the connector buckle. To connect the buckle: 1. Remove the seat belt tongue and connector 1 . tongue from the seat belt hook * 2. Pull the seat belt and secure the connector 2 . buckle until it clicks * The rear center seat belt connector tongue can be attached only into the rear center seat belt connector buckle. To fasten the seat belt, see "Fastening the seat belts" earlier in this section. 2. Retract the seat belt and secure the seat belt tongue and connector tongue on the 3 . seat belt hook * WARNING . When attaching the rear center seat belt connector, be certain that the seatbacks are completely secured in the latched position and the rear center seat belt connector is completely secured. If the rear center seat belt connector and the seatbacks are not secured in the correct position, serious personal injury may result in an accident or sudden stop. WARNING . Do not unfasten the rear center seat belt connector except when folding down the rear seat. When returning the seatback, be sure to attach the rear center seat belt connector. Attaching rear center seat belt: Always be sure the rear center seat belt connector tongue and connector buckle are attached. Disconnect only when folding down the rear seat. . SSS0966 . 1-20 Safety - Seats, seat belts and supplemental restraint system