2011 Nissan cube Owner's Manual - Page 327

¯ m MODELS FOR Kro Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the vinyl bag...License plate bracket J-nut 6 2 Screw 6 4 Screw grommet 6 4 7. Insert a flat-blade screwdriver into the grommet hole to add a 908 turn onto the E . part * 8. Insert a J-nut into the license plate bracket before placing the license plate bracket on the fascia. 9. Install the license plate bracket with the screws. 10. Install the license plate with bolts that are not longer than 0.55 in (14 mm). 1. Park the vehicle on flat, level ground. 2. Temporarily place the license plate bracket A of the front bumper while aligning points * B in the license plate fascia with holes * bracket. A and * B are aligned. 3. Confirm that points * Hold the license plate bracket and mark the C on the bumper facia through the points * D with a felt-tip pen. center of the holes * 4. Remove the license plate bracket. A 5. Carefully drill two shallow pilot holes * C using a 0.39 in (10 mm) drill bit at and * the marked locations. (Be sure that the drill only goes through the fascia, or damage to the nut may occur.) 6. Insert grommets into the hole on the fascia. Technical and consumer information 9-13