2011 Nissan cube Owner's Manual - Page 325
2011 Nissan cube Manual
Page 325 highlights
INSTALLING FRONT LICENSE PLATE ¯ m MODELS EXCEPT FOR Kro Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag...License plate bracket J-nut 6 2 Screw 6 2 Screw grommet 6 2 1. Park the vehicle on flat, level ground. A on the lower 2. Locate the center position * part of the air duct. Measure straight down from the edge where the bumper and air B , keeping duct meet to the aligning holes * the tape measure lined up with the center position. 3. Mark the holes B 4. Carefully drill the two aligning holes * using a 0.39 in (10 mm) drill bit at the marked locations. (Be sure that the drill only goes through the bumper fascia.) C 5. Line up the bosses * or license plate bracket with the holes and hold the license plate bracket in place. B * with a felt-tip pen. STI0647 Technical and consumer information 9-11