2012 Nissan Titan Owner's Manual - Page 139
2012 Nissan Titan Manual
Page 139 highlights
NOTE: When programming a garage door opener, etc., it is advised to unplug the device during the "cycling" process to prevent possible damage to the garage door opener components. OPERATING THE HOMELINKா UNIVERSAL TRANSCEIVER The HomeLinkா Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed HomeLinkா Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted. ● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. Hold the transmitter in that position for up to 15 seconds. If HomeLinkா is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone numbers are located in the Foreword of this manual. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLinkா surface. 3. Press and hold the hand-held transmitter button. 4. The HomeLinkா indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The HomeLinkா Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLinkா button that was just programmed. This procedure will not affect any other programmed HomeLinkா buttons. CLEARING THE PROGRAMMED INFORMATION Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). PROGRAMMING TROUBLEDIAGNOSIS If the HomeLinkா does not quickly learn the handheld transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-held transmitter with its battery area facing away from the HomeLinkா surface. ● press and hold both the HomeLinkா and hand-held transmitter buttons without interruption. IF YOUR VEHICLE IS STOLEN If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLinkா. Consult the Owner's Manual of each device or call the manufacturer or dealer of those devices for additional information. When your vehicle is recovered, you will need to reprogram the HomeLinkா Universal Transceiver with your new transmitter information. REPROGRAMMING A SINGLE HOMELINKா BUTTON To reprogram a HomeLinkா Universal Transceiver button, complete the following. 1. Press and hold the desired HomeLinkா button. Do not release the button until step 4 has been completed. 2-58 Instruments and controls