2012 Nissan Titan Owner's Manual - Page 167

● If the battery cable is disconnected, or if the fuse opens, the memory storage function will be canceled and must be restarted before a stored memory position can be set again. Drive the vehicle over 25 MPH (40 km/h) to restart the memory storage function. You can also restart the memory storage function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than 2 times with the ignition switch in the LOCK position. Once the memory storage function has been restarted, you can store a memory position. See "Memory storage function" in this section. The driver's seat, accelerator and brake pedals, and outside mirrors will move to the memorized position with the indicator light blinking, and then the light will stay on for approximately 5 seconds. ● When the ignition switch is turned from ACC to ON while the shift selector is in the P (Park) position. The entry/exit function can be adjusted or canceled. For vehicles with a navigation system, see "Vehicle electronic systems" in the "Display screen, heater, air conditioner, audio and phone systems" section of this manual. For vehicles without navigation system, see your NISSAN dealer. ENTRY/EXIT FUNCTION This system is designed so that the driver's seat will automatically move when the shift selector is placed in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward: ● When the key is removed from the ignition switch and the driver's door is opened. ● When the driver's door is opened with the ignition switch placed in the LOCK position. ● When the ignition switch is turned from ACC to LOCK with the driver's door open. The driver's seat will return to the previous position: ● When the key is inserted into the ignition switch and the driver's door is closed. ● When the driver's door is closed with the ignition switch placed in the LOCK position. Restarting the entry/exit function If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled. Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure. 1. Connect the battery cable or replace the fuse. 2. Open and close the driver's door more than 2 times with the ignition switch in the LOCK position. The entry/exit function should now work properly. Selecting the memorized position Set the shift selector to the P (Park) position, then: ● Within 45 seconds of opening the driver's door, push the memory switch (1 or 2) or ● Place the ignition switch in the ON position and push the memory switch (1 or 2). 3-26 Pre-driving checks and adjustments