2014 Nissan 370Z Owner's Manual - Page 210
2014 Nissan 370Z Manual
Page 210 highlights
During satellite radio reception, the following notices will be displayed under certain conditions...NO SIGNAL (No signal is received while the SAT tuner is connected.) OFF AIR (Broadcasting signed off) CHECK ANTENNA (Antenna connection error) LOADING (When the initial setting is performed) UPDATING (When the satellite radio subscription is not active) 1. Choose the radio band using the radio band select button. 2. Tune to the desired station/channel using the SEEK, SCAN or TUNE button. 3. Push and hold the desired radio station 1 to * 6 until a beep sound preset button * is heard. (The radio mutes when the select button is pushed.) 4. The station indicator will then come on and the sound will resume. Memorizing is now complete. 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse opens, the radio memory will be erased. In that case, reset the desired stations. RADIO DISPLAY change: When the DISP button is pushed while the radio is being played, the audio display will change as follows: Compact Disc (CD) changer operation Push the ignition switch to the ACC or ON position, push the LOAD button and insert the CD into the slot with the label side facing up. The CD will be guided automatically into the slot and start playing. After loading the CD, the number of tracks on the CD and the play time will appear on the display. If the radio is already operating, it will automatically turn off and the CD will play. If the system has been turned off while the CD was playing, pushing the ON·OFF button will start the CD. CD LOAD: To insert a CD in the CD changer, push the LOAD button for less than 1.5 seconds. Select the loading position by pushing the CD insert 1 to * 6 , then insert the CD. select button * To insert 6 CDs to the CD changer in succession, push the LOAD button for more than 1.5 seconds. The inserted slot numbers will illuminate on the display. SCAN tuning: Push the SCAN tuning button to tune from low to high frequencies and stop at each broadcasting station/channel for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station/channel. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station/channel. 1 to * 6 Station memory operations: * 18 stations/channels can be set for the SAT band (6 each for XM1, XM2 and XM3), 12 can be set for the FM band (6 each for FM1 and FM2), and 6 can be set for the AM band. Center display, heater, air conditioner, audio, phone and voice recognition systems 4-49