2014 Nissan 370Z Owner's Manual - Page 333
2014 Nissan 370Z Manual
Page 333 highlights
NOTE: The compressor tire pressure gauge may show a pressure reading of 87 psi (600 kPa) for about 30 seconds while inflating the tire. The pressure gauge is indicating the pressure inside the sealant can. When the sealant has been injected into the tire the pressure gauge will drop and indicate actual tire pressure. WARNING SCE0870 A of the hose 5. Remove the protective cap * and screw the hose securely onto the tire valve. Make sure that the pressure release B is securely tightened. Make sure valve * that the air compressor switch is in the OFF (*) position, and then insert its power plug into the power outlet in the vehicle. SCE0871 . 6. Push the ignition switch to the "ACC" position. Then turn the compressor switch to the ON (−) position and inflate the tire up to the pressure that is specified on the tire and loading information label affixed to the driver's side center pillar if possible, or to the minimum of 180 kPa (26 psi). Turn the air compressor off briefly in order to check the tire pressure with the pressure gauge. If the tire is inflated to higher than the specified pressure, lower the tire pressure by releasing air with the pressure release valve. To avoid serious personal injury while using the emergency tire puncture repair kit: - Securely tighten the compressor hose to the tire valve. Failure to do so can cause the sealant to spray into the air and get into your eyes or on the skin. . Do not stand directly beside the damaged tire while it is being inflated because of the risk of the rupture. If there are any cracks or bumps, turn the compressor off immediately. If the tire pressure does not increase to 180 6-12 In case of emergency