2014 Nissan 370Z Owner's Manual - Page 248

. . . . slow down or disconnect the communication and cause undesired noise. It is recommended that you turn off the wireless LAN (Wi-Fi) when using the Bluetooth® functions. Set up the wireless connection between a compatible cellular phone and the in-vehicle phone module before using the Bluetooth® Hands-Free Phone System. Some Bluetooth® enabled cellular phones may not be recognized by the in-vehicle phone module. Please visit www.nissanusa. com/bluetooth for a recommended phone list and connecting. You will not be able to use a hands-free phone under the following conditions: - Your vehicle is outside of the telephone service area. - Your vehicle is in an area where it is difficult to receive radio waves; such as in a tunnel, in an underground parking garage, near a tall building or in a mountainous area. - Your cellular phone is locked to prevent it from being dialed. When the radio wave condition is not ideal or ambient sound is too loud, it may be difficult to hear the other person's voice during a call. . . . . . . . Immediately after the ignition switch is pushed to the ON position, it may be impossible to receive a call for a short period of time. Do not place the cellular phone in an area surrounded by metal or far away from the invehicle phone module to prevent tone quality degradation and wireless connection disruption. While a cellular phone is connected through the Bluetooth® wireless connection, the battery power of the cellular phone may discharge quicker than usual. The Bluetooth® Hands-Free Phone System cannot charge cellular phones. If the Bluetooth® Hands-Free Phone System seems to be malfunctioning, please contact a NISSAN dealer. Some cellular phones or other devices may cause interference or a buzzing noise to come from the audio system speakers. Storing the device in a different location may reduce or eliminate the noise. Refer to the cellular phone Owner's Manual regarding battery charging, cellular phone antenna, etc. This wireless hands free car kit is based on Bluetooth® technology, - Frequency: 2402 MHz - 2480 MHz - Output Power: 4.14 dBm E.I.R.P - Modulation: FHSS GFSK 8DPSK, p/ 4DQPSK - Number of Channel: 79 - This wireless equipment can't be used for any services related to safety because there is the possibility of radio interference. REGULATORY INFORMATION FCC Regulatory information . CAUTION: To maintain compliance with FCC's RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC regulations. . Operation is subject to the following two conditions: 1. this device may not cause interference and 2. this device must accept any interference, including interference that may cause undesired operation of the device Center display, heater, air conditioner, audio, phone and voice recognition systems 4-87