2014 Nissan 370Z Owner's Manual - Page 364

. Check your local regulations. (Perform steps 4 to 7 only when the engine oil filter change is needed.) 2 4. Loosen the oil filter * with an oil filter wrench. Remove the oil filter by turning it by hand. Drain plug tightening torque: 22 to 29 ft-lb (29 to 39 N·m) Do not use excessive force. 9. Refill engine with recommended oil through the oil filler opening, and install the oil filler cap securely. See "Capacities and recommended fuel/ lubricants" (P.9-2) for drain and refill capacity. The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine the proper amount of oil in the engine. 10. Start the engine and check for leakage around the drain plug and the oil filter. Correct as required. 11. Turn the engine off and wait more than 15 minutes. Check the oil level with the dipstick. Add engine oil if necessary. 5. Wipe the engine oil filter mounting surface with a clean rag. CAUTION SDI2335 Engine oil and filter 1. Place a large drain pan under the drain plug. 2. Remove the oil filler cap. 1 with a wrench 3. Remove the drain plug * and completely drain the oil. Be sure to remove any old rubber gasket remaining on the mounting surface of the engine. Failure to do so could lead to engine damage. 6. Coat the gasket on the new filter with clean engine oil. 7. Screw in the oil filter clockwise until a slight resistance is felt, then tighten additionally more than 2/3 turn. Oil filter tightening torque: 11 to 15 ft-lb (14.7 to 20.5 N·m) 8. Clean and re-install the drain plug with a new washer. Securely tighten the drain plug with a wrench. CAUTION Be careful not to burn yourself, as the engine oil is hot. . After the operation 1. Install the engine undercover into position as the following steps. a. Pull the center of the small plastic clip out. b. Hold the engine undercover into position. Maintenance and do-it-yourself 8-11 Waste oil must be disposed of properly.