2005 Subaru Legacy Owner's Manual - Page 351
2005 Subaru Legacy Manual
Page 351 highlights
Interior equipment If the indicator light flashes rapidly for two seconds and then stays on continuously, your garage door opener may be protected by a rolling code feature. In this case you need to perform the additional steps for "Rolling-code-protected garage opener programming in the U.S.A." described below. NOTE Rolling-code-protected garage door openers are manufactured after 1996. See the instruction manual of your garage opener for confirmation. UB6219CA 4. Using both hands, simultaneously push the handheld transmitter button and the desired HomeLink® button. DO NOT release the buttons until step 5 has been completed. 5. Hold down both buttons until the HomeLink® indicator light flashes, first slowly then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapidly flashing light indicates successful programming of the new frequency signal.) 6. Press and hold the programmed button and check the HomeLink® indicator light. If the indicator light stays on continuously, your garage door should activate and the programming is completed. 6-34 7. Reconnect the motor of your garage door opener to the outlet. 8. Test your garage door opener by pressing the programmed HomeLink® button. ! Programming rolling-code-protected garage door openers in the U.S.A. If your garage door opener has a rolling code feature, program the HomeLink® Wireless Control System for it by following steps 1 through 5 in the "Programming garage door openers in the U.S.A." section above and then continuing the steps below. NOTE The assistance of a second person may make the programming quicker and easier.