2007 Subaru Outback Owner's Manual - Page 104
2007 Subaru Outback Manual
Page 104 highlights
Keys and doors 2-15 . Opening a door, the rear gate or trunk lid . Physical impact to the vehicle, such as forced entry (only vehicles with shock sensors (dealer option)) & Activating and deactivating the alarm system To change the setting of your vehicle's alarm system for activation or deactivation, do the following. 1. Disarm the alarm system (see "Disarming the system" in this section). 2. Sit in the driver's seat and shut all doors (and the rear gate if your vehicle is a Station wagon). 3. Turn the ignition switch to the "ON" position. 4. Hold down the UNLOCK side of the driver's power door locking switch, open the driver's door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows: If the system was previously activated: For non-turbo models, the odometer/trip meter screen displays "AL oF", and for turbo models, the multi-information display shows "Security alarm: OFF" and the horn sounds twice, indicating that the system is now deactivated. If the system was previously deactivated: For non-turbo models, the odometer/trip meter screen displays "AL on", and for turbo models, the multi-information display shows "Security alarm: ON" and the horn sounds once, indicating that the system is now deactivated. NOTE You may have the above setting change done by your SUBARU dealer. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood (and the trunk lid on the Sedan) are locked. 5. Close all doors (and the rear gate on the Station wagon). & If you have accidentally triggered the alarm system ! To stop the alarm Do any of the following operations: . Insert the key in the door lock of the driver's door and turn it to the unlock position. . Press any button on the remote transmitter. . Turn the ignition switch to the "ON" position. : Press to Arm the system. : Press to Disarm the system. & Arming the system ! To arm the system using remote transmitter 1. Close all windows and the moonroof (if so equipped). - CONTINUED -