2007 Subaru Outback Owner's Manual - Page 352

11-16 Maintenance and service room to add genuine Subaru cooling system conditioner in the radiator. Add genuine Subaru cooling system conditioner until the coolant level reaches the filler neck. Do not pour the coolant too quickly, as this may lead to insufficient air bleeding and trapped air in the system. Coolant capacity (Guideline): 2.5-liter non-turbo models: MT. 6.8 US qt (6.4 liters, 5.6 Imp qt) AT. 6.7 US qt (6.3 liters, 5.5 Imp qt) 2.5-liter turbo models: MT. 7.7 US qt (7.3 liters, 6.4 Imp qt) AT. 7.6 US qt (7.2 liters, 6.3 Imp qt) 3.0-liter models: 7.6 US qt (7.2 liters, 6.3 Imp qt) may damage the paint surface. Non-turbo models 1) Fill up to here 6. Pour the coolant and fill to the reservoir tank's "FULL" level mark. CAUTION . Be careful not to spill engine coolant when adding it. If coolant touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If engine coolant gets on the exhaust pipe, be sure to wipe it off. . Do not splash the engine coolant over painted parts. The alcohol contained in the engine coolant Turbo models 1) Fill up to here 5. Slowly pour the coolant and fill up to just below the filler neck, allowing enough 7. Put the radiator cap back on and tighten firmly. At this time, make sure that