2007 Subaru Outback Owner's Manual - Page 389

Maintenance and service 11-53 ! High beam light bulbs 2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction. (left-hand side) place and secure it by clip. (left-hand side) & Parking light It may be difficult to replace the bulbs. Have your SUBARU dealer replace the bulbs if necessary. & Front turn signal light It may be difficult to replace the bulbs. Have your SUBARU dealer replace the bulbs if necessary. & Front fog light (if equipped) Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. (right-hand side) It may be difficult to replace the bulbs. Have your SUBARU dealer replace the bulbs if necessary. 3. Disconnect the electrical connector from the bulb. 4. Remove the bulb from the headlight assembly by turning it counterclockwise. 5. Replace the bulb with new one. 6. Reconnect the electrical connector. At this time, use care not to touch the bulb surface. 7. To install the bulb to the headlight assembly, turn it clockwise until it clicks. 8. Install the air intake duct with clip. (right-hand side) 9. Set the washer tank to the original - CONTINUED - Left-hand side