2009 Subaru Tribeca Owner's Manual - Page 108
2009 Subaru Tribeca Manual
Page 108 highlights
2-12 Keys and doors 6. Replace with a new battery (Type CR1620 or equivalent) making sure to install the new battery with the negative (−) side facing up. 7. Put together the transmitter case by fitting the hooks on both sides of the case. 8. Put the transmitter case in the key head and then put together the key head. 9. Reinstall the screw on the key head. After the battery is replaced, the transmitter must be synchronized with the remote keyless entry system's control unit. Press either the " " or " " button six times to synchronize the unit. different. Programming transmitter codes into system: & Replacing lost transmitters If you lose a transmitter or want to purchase additional transmitters (up to four can be programmed), you should reprogram all of your transmitters for security reasons. It is recommended that you have your dealer program all of your transmitters into your system. ! Programming the transmitters The remote keyless entry system is equipped with a special code learning feature that allows you to program new transmitter codes into the system or to delete old ones. The system can learn up to four unique transmitter codes. The four transmitter codes may be the same or Key tag remote keyless entry system, it is necessary to program the transmitter's code (identification number) into the system. A tag showing the code is affixed to the key unit, and another is affixed to the circuit board inside the transmitter. If there is no tag, open the transmitter case and make a note of the eight-digit number. Program the number into the system in accordance with the following procedure: 1. Firmly close the doors and the rear gate. 2. Open the driver's door, sit on the driver's seat, and close the door. 3. Perform the following steps within 45 seconds. Transmitter circuit board (1) Open and close the driver's door once. To register a new transmitter with the