2010 Volvo S40 Owner's Manual - Page 106
2010 Volvo S40 Manual
Page 106 highlights
04 Interior Front seats Programming the seat memory, driver's seat only* 3. With the "M" button depressed, press memory button 1 to store the seat's current position. To move the seat to the position that it was in when memory button 1 was programmed, press and hold down button 1 until the seat stops moving. As a safety precaution, the seat will stop automatically if the button is released before the seat has reached the preset position. 04 NOTE The memory function in the remote key operates independently the memory function in the seat. WARNING • Because the driver's seat can be adjusted with the ignition off, children should never be left unattended in the car. Movement of the seat can be STOPPED at any time by pressing any button on the power seat control panel. Do not adjust the seat while driving. The seat should be adjusted so that the brake pedal can be depressed fully. In addition, position the seat as far rearward as comfort and control allow. The seat rails on the floor must not be obstructed in any way when the seat is in motion. Central locking system remote key and driver's seat memory The remote key transmitter can also be equipped with an optional function that controls the electrically operated driver's seat in the following way: 1. Adjust the seat to the desired position. 2. When you leave the car, lock it using the remote key. 3. The next time the driver's door is unlocked with the same remote key and that door is opened within 2 minutes, the driver's seat and side door mirrors will automatically move to the position that they were in when the doors were most recently locked with the same remote key. G020200 • • Power seat memory buttons Three different seating positions can be stored in the seat's memory. The memory buttons are located on the outboard side of the driver's seat (see the illustration above). The following example explains how memory button 1 can be programmed. Buttons 2 and 3 can be programmed in the same way. To program (store) a seat position in memory button 1: 1. Adjust the seat to the desired position. 2. Press and hold down the "M" (Memory) button. • 106 * Option/accessory, for more information, see Introduction.