2010 Volvo S40 Owner's Manual - Page 193

07 Wheels and tires Changing a wheel WARNING Installing the wheel 1. Clean the contact surfaces on the wheel and hub. 2. Lift the wheel and place it on the hub. 3. Install the wheel nuts and tighten handtight. Using the lug wrench, tighten crosswise until all nuts are snug. 4. Lower the vehicle to the ground and alternately tighten the bolts crosswise to 81 ft. lbs. (110 Nm). 5. Install the wheel cover (where applicable). WARNING The jack and any tools should always be returned to their proper storage compartments after use to help keep them securely in place in the event of sudden braking, etc. The jack must correctly engage the jack attachment. Be sure the jack is on a firm, level, nonslippery surface. Never allow any part of your body to be extended under a car supported by a jack. Use the jack intended for the car when changing a tire. For any other job, use stands to support the car. Apply the parking brake and put the gear selector in the Park (P) position or reverse on models with a manual transmission. Block the wheels standing on the ground, use rigid wooden blocks or large stones. The jack should be kept well-greased and clean, and should not be damaged. No objects should be placed between the base of jack and the ground, or between the jack and the attachment bar on the vehicle. Returning the jack to its storage space The jack (certain models) and tools should be returned to their correct storage places after use. • • • • On vehicles equipped with a jack and spare wheel, the jack should be cranked down and returned to its storage position after use. • On vehicles equipped with the tire sealing system, the jack should be cranked down as far as possible and returned to its storage position in the foam block. 07 193