2010 Volvo S40 Owner's Manual - Page 161

06 Starting and driving Jump starting Jump starting the vehicle your vehicle's battery (2), marked with a "+" sign. 3. Connect the auxiliary battery's negative (-) terminal (3) to the ground point in your vehicle's engine compartment near the driver's side spring strut (4). 4. Start the engine in the assisting vehicle, then start the engine in the vehicle with dead battery. 5. After the engine has started, first remove the negative (-) terminal jumper cable. Then remove the positive (+) terminal jumper cable. WARNING • • • Do not connect the jumper cable to any part of the fuel system or to any moving parts. Avoid touching hot manifolds. Batteries generate hydrogen gas, which is flammable and explosive. Battery fluid contains sulfuric acid. Do not allow battery fluid to contact eyes, skin, fabrics or painted surfaces. If contact occurs, flush the affected area immediately with water. Obtain medical help immediately if eyes are affected. Never expose the battery to open flame or electric spark. Do not smoke near the battery. Failure to follow the instructions for jump starting can lead to personal injury. Do not touch the jumper cables during the attempt to start the vehicle. This could cause sparks. 06 G020298 Follow these instructions to jump start your vehicle's dead battery or to jump start another vehicle's dead battery using your vehicle. If the 12-volt auxiliary battery to be used is in another vehicle, check that the vehicles are not touching to prevent premature completion of a circuit. Be sure to follow jump starting instructions provided for the other vehicle. To jump start your vehicle: 1. Switch off the ignition. 2. First connect the auxiliary battery positive (+) terminal (1) to the positive (+) terminal in WARNING PROPOSITION 65 WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the state of California to cause cancer and reproductive harm. Wash hands after handling. 161