2010 Volvo S40 Owner's Manual - Page 126

05 Locks and alarm Keyless drive* Locking or unlocking the vehicle with the key blade to unlock the driver's door only. This will trigger the alarm. NOTE If several people carrying keyless drive remote keys approach the vehicle at the same time, the driver's seat will assume the position it was in for the person who opens a door first. • To disable the alarm: Press the Unlock button on the keyless drive remote key. If the batteries in the remote are weak, remove the keyless drive start control from the ignition switch by pressing the catch (see the illustration on page 148) and pulling the control out of the ignition switch. Insert the ignition key section of a keyless drive remote key in the ignition switch. Keyless drive information messages If anyone leaves the vehicle with the only keyless drive remote key in his or her possession while the ignition is switched on, a message will be shown in the information display and an audible signal will sound. Keyless drive remote key and driver's seat memory G020225 05 Keyless drive keyhole cover This function is only available on vehicles equipped with the optional power driver's seat. NOTE This message will only be displayed if the start control is in position I or II. • When you leave the car with a keyless drive remote key in your possession and lock any door, the position of the driver's seat will be stored in the seat's memory. The driver's door on vehicles equipped with keyless drive can be locked or unlocked with the remote key's detachable key blade if necessary, see page 121 for information on removing the key blade from the remote key. To access the keyhole in the driver's door: • The next time a door is opened by a person with the same remote key in his/her possession, the driver's seat will automatically move to the position that it was in when the door was most recently locked. The message will be erased from the display and the audible signal will stop when the remote key has been returned to the vehicle and one of the following has occurred: • Pry off the keyhole cover by inserting the key blade or a small screwdriver in the hole on the underside of the cover (indicated by the arrow in the inset illustration). • A door has been opened and closed • The start control has been turned to position 0 • The READ button (see page 60 for the location of this button) has been pressed. • Insert the key blade as far as possible in the driver's door lock. Turn the key blade clockwise approximately one-quarter turn 126 * Option/accessory, for more information, see Introduction.