AEG BSK892330M User Manual - Page 57
Refer to Be, fore first use,
View all AEG BSK892330M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
ENGLISH 57 Problem Possible cause The oven does not heat up. The fuse is blown. The lamp does not operate. The lamp is defective. The display prompts to set There was a power cut lon- the Language ger than 3 days. Remedy Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. Replace the lamp. WARNING! Refer to "Before first use" chapter. The display shows F111. The plug of the core temperature sensor is not correctly installed into the socket. Put the plug of the core temperature sensor as far as possible into the socket. The display shows an error There is an electrical fault. code that is not in this table. • Deactivate the oven with the house fuse or the safety switch in the fuse box and activate it again. • If the display shows the error code again, contact the Customer Care Department. Steam and condensation You left the dish in the oven settle on the food and in the for too long. cavity of the oven. Do not leave the dishes in the oven for longer than 15 20 minutes after the cooking process ends. The display prompts to set The demo mode is activa- the Language. ted. Turn off Demo in Menu: Basic Settings: Demo. Activation / deactivation code: 2468. The appliance does not retain the water drawer after you insert it. You did not assemble the lid Assemble the lid of the waof the water drawer correct- ter drawer correctly. ly. Water comes out of the water drawer after you carry it or put it inside the appliance. You did not assemble the lid Assemble the lid of the waof the water drawer correct- ter drawer correctly. ly. Water comes out of the water drawer after you carry it or put it inside the appliance. You did not assemble the wave-breaker correctly. Assemble the wave-breaker in the body of the water drawer correctly.