AEG L75480WD Product Manual - Page 6
Technical Information - not drying
View all AEG L75480WD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
6 www.aeg.com • Make sure not to cause damage to the mains plug and cable. • Connect the mains plug to the mains socket only at the end of the installation. Make sure that there is access to the mains plug after the installation. • Do not pull the mains cable to disconnect the appliance. Always pull the mains plug. • Only for UK and Ireland. The appliance has a 13 amp mains plug. If it is necessary to change the fuse in the mains plug, use a 13 amp ASTA (BS 1362) fuse. • Permanent connection. To connect the appliance permanently, install a double-pole isolating switch between the appliance and the electricity supply. It must have a minimum distance of 3 mm between the switch contacts and it TECHNICAL INFORMATION must be the correct type for the necessary load. It must agree with the last electrical legislation. The switch must not break the yellow and green ground cable. Only a qualified electrician must install this type of device. DISPOSAL WARNING! Risk of injury or suffocation. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it. • Remove the door catch to prevent chil- dren and pets to get closed in the appliance. Dimensions Width / Height / Depth Total depth Electrical connection: Voltage Overall power Fuse Frequency Level of protection against ingress of solid particles and moisture ensured by the protective cover, except where the low voltage equipment has no protection against moisture Water supply pressure Minimum Maximum Water supply 1) Maximum wash load Cotton Maximum dry load Cotton Synthetics Spin speed Maximum 1) Connect the water inlet hose to a water tap with a 3/4'' thread. 600 / 850 / 605 mm 640 mm 230-240 V 2200 W 13 A 50 Hz IPX4 0,5 bar (0,05 MPa) 8 bar (0,8 MPa) Cold water 8 kg 6 kg 3 kg 1400 rpm