AEG ProTex Freestanding 60cm Washer Dryer White L87696WD Product Manual - Page 20
without the delay start
View all AEG ProTex Freestanding 60cm Washer Dryer White L87696WD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
20 www.aeg.com With the flap in the position DOWN: • Do not use gelatinous or thick liquid detergents. • Do not put more liquid detergent than the limit showed in the flap. • Do not set the prewash phase. • Do not set the delay start function. 5. Measure out the detergent and the fabric conditioner. 6. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 9.5 Activating the appliance 1. Open the water tap. 2. Connect the mains plug to the mains socket. 3. Press button On/Off to activate the appliance. A short tune sounds. 9.6 Setting a programme 1. Turn the programme knob and set the programme: • The related programme indicator comes on. • The indicator of Start/Pause flashes. • The display shows: the default temperature, the spin speed, the indicators of the programme phases and the programme duration. 2. If necessary, change the temperature, the spin speed, the cycle duration, or add available options. When you activate an option, the indicator of the set option comes on. If you set something incorrect, the display shows the message Err. 9.7 Starting a programme without the delay start Press button Start/Pause to start the programme. The relevant indicator stops to flash and stays on. On the display the indicator of the phase is operation starts to flash. The programme starts, the door is locked. The display show the indicator . The drain pump can operate for a short time when the appliance fills water. 9.8 Behaviour of the appliance After approximately 15 minutes from the start of the programme: • The appliance adjusts automatically the cycle time to the laundry you have put in the drum to have perfect washing results in the minimum necessary time. • The display shows the new time value. 9.9 Starting a programme with the delay start 1. Press button Delay Start again and again until the display shows the number of minutes or hours of delay. The related indicator comes on. 2. Press button Start/Pause. The appliance starts the countdown of the delay start. When the countdown is completed, the programme starts automatically. Before you press button Start/Pause to start the appliance, you can cancel or change the set of the delay start. 9.10 Cancelling the delay start To cancel the delay start: 1. Press button Start/Pause to set the appliance to pause.