AEG ProTex Freestanding 60cm Washer Dryer White L87696WD Product Manual - Page 21
Interrupting a, programme and changing a, function, Cancelling a running, programme, Opening
View all AEG ProTex Freestanding 60cm Washer Dryer White L87696WD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
The related indicator flashes. 2. Press button Delay Start repeatedly until the display shows . 3. Press button Start/Pause again to start the programme immediately. 9.11 Interrupting a programme and changing a function You can change only some options before they operate. 1. Press button Start/Pause. The related indicator flashes. 2. Change the function set. 3. Press the button Start/Pause again. The programme continues. 9.12 Cancelling a running programme 1. Press button On/Off to cancel the programme and to deactivate the appliance. 2. Press button On/Off again to activate the appliance. Now, you can set a new washing programme. Before starting the new programme the appliance could drain the water. In this case, make sure that the detergent is still in the detergent compartment, if not fill the detergent again. 9.13 Opening the door If the temperature and level of the water in the drum are too high and the drum still rotates you cannot open the door. While a programme or the delay start operates, the appliance door is locked. 1. Press button Start/Pause. In the display the related door lock indicator goes off. 2. Open the appliance door. 3. Close the door and press button Start/Pause. The programme or the delay start continues. ENGLISH 21 9.14 End of cycle When the programme has finished, the appliance stops automatically. The acoustic signal operates (if it is active). In the display comes on and the door locked indicator goes off. The indicator of Start/Pause button goes off. 1. Press button On/Off to deactivate the appliance. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance. When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cycle. 2. Remove the laundry from the appliance. 3. Make sure that the drum is empty. 4. Keep the door ajar, to prevent mildew and odours 9.15 Draining water out after end of cycle The washing programme is completed, but there is water in the drum: The drum turns regularly to prevent the creases in the laundry. The door lock indicator door stays locked. is on. The You must drain the water to open the door: 1. If necessary, decrease the spin speed. 2. Press the Start/Pause button. The appliance drains the water and spins. 3. When the programme is completed and the door lock indicator goes off, you can open the door . 4. Press On/Off some seconds to deactivate the appliance. The appliance drains and spins automatically after approximately18 hours.