AEG ProTex Freestanding 60cm Washer Dryer White L87696WD Product Manual - Page 34

34 www.aeg.com Problem The laundry is full of different colours fluff. Possible solution Reduce the laundry load. Make sure you have set the correct cycle. if necessary ,set again a short drying time. The fabrics washed in the previous cycle released fluff of a different colour: • The drying phase helps to eliminate some fluff. • Clean the clothes with a fluff remover. In case of an excessive amount of fluff in the drum run the special programme to clean it (refer to "Fluff in the fabrics" for more details). After the check, activate the appliance. The programme continues from the point of interruption. If the problem occurs again, contact the Authorised Service Centre. If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues, contact the Authorised Service Centre. 14.3 Emergency door opening In case of power failure or appliance failure the appliance door remains locked. The washing programme continues, when the power is restored. If the door remains locked in case of failure, it is possible to open it using the emergency unlock feature. Before opening the door: CAUTION! Make sure that the water temperature and the laundry are not hot. Wait till they cool down, if necessary. To open the door, proceed as follows: 1. Press the button On/Off to switch the appliance off. 2. Disconnect the mains plug from the mains socket. 3. Open the filter flap. 4. Keep the emergency unlock trigger pulled downward and, at the same time, open the appliance door. CAUTION! Make sure that the drum is not rotating. Wait till the drum stops rotating, if necessary. Make sure that the water level inside the drum is not too high. Proceed with an emergency drain, if necessary (refer to «Emergency drain» in «Care and cleaning» chapter). 5. Take out the laundry and then close the appliance door. 6. Close the filter flap.