AIWA AWP-ZX7 Operating Instructions - Page 31

AIWA AWP-ZX7 Manual

Page 31 highlights

To place the sub woofer To obtain a better bass reproduction, we recommend you to place the subwoofer on a solid floor where resonance is unlikely to occur. Notes Listening to audio from a connected component 1 2 Connect audio cords. • Always place the subwoofer vertically, keeping it a few centimeters away from the wall. • If the sub woofer is placed in the center of a room, the bass could be extremely weakened. This is due to the influence of the standing wave of the room. If this happens, move the subwoofer away from the center of the room or eliminate the cause of the standing wave, by placing a bookshelf against the wall, etc. See "Hooking up optional components" on page 30. Press FUNCTION repeatedly until "AUX" appears. Start playing the connected component. C AUX IN jacks Use audio cords (not supplied) to connect an optional analog component (MD deck or VCR, etc.) to these jacks. You can then listen to the sound from the component. 31GB Optional Components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

Optional Components
31
GB
To place the sub w oofer
To obtain a better bass reproduction, we
recommend you to place the subwoofer on a
solid floor where resonance is unlikely to occur.
Notes
Always place the subwoofer vertically, keeping it a
few centimeters away from the wall.
If the sub woofer is placed in the center of a room, the
bass could be extremely weakened. This is due to the
influence of the standing wave of the room. If this
happens, move the subwoofer away from the center
of the room or eliminate the cause of the standing
wave, by placing a bookshelf against the wall, etc.
C
AUX IN jacks
Use audio cords (not supplied) to connect an
optional analog component (MD deck or VCR,
etc.) to these jacks. You can then listen to the
sound from the component.
1
Connect audio cords.
See “Hooking up optional components” on
page 30.
2
Press FUNCTION repeatedly until
“AUX” appears.
Start playing the connected component.
Listening to audio from a
connected component