AIWA CSD-ED37 Operating Instructions - Page 4

REPEAT/ FM MODE/ Osc STOPIMEMORY~ @@ - TUNING+ POWE(!R)STANDBY BAND TAPE H ""'0 I-kL.J ~ Press *RADIO/BAND repeatedly to select the desired band. ~FM--+AMT The power is turned on and the previously tuned station is received. The RADIO indicator lights up. * or BAND on the remote control when the AC cord is connected (except CSD-ED37) z Press 1+4, BI (+, - TUNING) to select a station. During FM stereo reception, ~ is displayed. After listening, press POWER (!) STANDBY to turn the power off. For better reception $% P NOTE If the unit picks up noise from other electrical appliances nearby, like a TV or fluorescent lights, move the unit. You can preset up to 15 stations in each band. Select a station. Press *9 STOP/MEMORY once so that "M" is displayed to store the station. A station is assigned a preset number, beginning from 1 in consecutive order for each band. "M" may not be displayed if the button is kept pressed for more than 0.5 second. Preset number Extend the FM antenna and orient it for the best reception. For quick tuning The AM antenna is inside the unit. Position the unit for the best reception. Keep i-, - TUNING pressed until the tuner starts searching for a station. When a station is tuned to, the search stops. If the broadcast signal is weak, it does not stop. To stop the search manually, press -1- or -. *REPEAT/FM MODE/OSC - If an FM stereo broadcast contains noise, press the button so that _ is displayed. Noise is reduced, although reception is monaural. To restore stereo reception, press the button again. - If a high-pitched sound is heard during AM recording, press the button repeatedly until the noise is reduced. Its position can be checked by "*" being on or off the display. * or MODE on the remote control (except CSD-ED37) To change the AM tuning interval The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the interval as follows. 1 Press RADIO/BAND to display FM. 2 Press s while pressing RADIO/BAND to display the AM frequency. When the AM tuning interval is changed, the preset stations are cleared. 4 ENGLISH Frequency * or s on the remote control (except CSD-ED37) B Repeat steps 1 and 2. The next station will not be stored if a total of 15 preset stations have already been stored for a band. TO listen to preset stations Select a band then press -11 repeatedly. - PLAY on the remote control PLAY/PAUSE/PRESET is also available. To select a preset number directly with the remote control (except CSD-ED37) Press the numbered buttons O-9 and +1 O. Example: To select number 15, press +10 and 5. To select number 10, press +10 and O. To clear a preset station Display the preset number first. Then, press s while the preset number is displayed. The higher numbers in the band are decreased by one,