AIWA CX-NAJ54 Operating Instructions - Page 19
Timer Recording
View all AIWA CX-NAJ54 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
TIMER 5 Adjust the volume. The source sound will play at the volume level set in this step when the power is turned on by the timer. If the volume level is set to 17 or higher, however, it will automatically be set to 16 when the power is turned on. 6 Prepare the source. To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2. To listen to the radio, select the band and tune in to a station. 7 Press POWER to turn off the power. When the timer-on time is reached, the unit turns on and begins play with the selected source. You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER or a in step 3. To check the timer setting Press TIMER. The timer-on time, the selected source, and the duration for the timer-activated period will be displayed for 4 seconds. To change any of the previous setting Carry out from step 1. However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4. To cancel the timer standby mode temporarily Press TIMER repeatedly so that 5 disappears. To restore the timer standby mode, press again to display 5. Using the unit while the timer is set You can use the unit normally after setting the timer. Before turning off the power, carry out step 5 and 6. TIMER RECORDING Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only. Press either TUNER BAND or VIDEO/AUX to select a source, then press TIMER repeatedly until 5 flashes on the display. Within 6 seconds, carry out the steps of "SETTING THE TIMER" from step 3 and insert the tape to be recorded on into deck 2 after step 6. • If the timer recording is done with the economizing mode (page 6) set to "ECO ON" or "ECO AUTO" and the power turns off, the dimmer mode will be set to dimmest and the volume level will be 0 (minimum level) the next time the power is turned on. • You cannot use the timer function to record from a CD or tape. • You can check the timer setting by pressing TIMER even while the power is off. In this case, if you press ENTER or a within 4 seconds after pressing TIMER, you can enter the timer setting mode and change the previous setting. En • Timer playback and timer recording will not begin unless the power is turned off. • Connected equipment cannot be turned on and off by the builtin timer of this unit. Use an external timer. ENGLISH 19