Adaptec 2100S Quick Start Guide - Page 21
Installing I, O Drivers
![]() |
View all Adaptec 2100S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
The following table describes the Bus Status LEDs for 3000S SCSI RAID controllers. TERMPWR-A TERMPWR-B TRMEN-A TRMEN-B TRMENHD-A These LEDs are lit when termination power is supplied by the controller for the respective channels. These LEDs are lit when termination is enabled on the controller for the respective channels. This indicates the upper 8 bits of the A channel (Bus 0) are terminated to support an 8-bit bus segment. This LED is lit when the High-Only option is selected for bus termination. Installing I2O Drivers Your new Adaptec controller uses I2O drivers supplied by Adaptec or your operating system vendor. This section discusses driver and operating system installation when using Adaptec controllers. After you install the operating system, you can install Storage Manager or Storage Manager Pro. These applications are available for the platforms listed in Installing Adaptec Storage Management Software on page 32. 20
![](/manual_guide/products/adaptec-2100s-quick-start-guide-8772e5b/21.png)