Adaptec 2100S Quick Start Guide - Page 25
Upgrading Windows NT to Windows 2000, Adding to an Existing Windows 2000 System - setup
View all Adaptec 2100S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
For specific procedures, see the Installation Guide for your controller. You only have five seconds to press F6 during the install startup. A prompt appears at the bottom of the screen when the F6 key is active. If you do not press F6 at this time, you must restart the Windows 2000 install process to complete the procedure correctly. Upgrading Windows NT to Windows 2000 Install the Adaptec controllers and storage devices according to the instructions in Installing and Configuring Hardware on page 9. For specific information, see the Installation Guide for your controller. Adding to an Existing Windows 2000 System 1 Install the Adaptec controller and storage devices according to instructions in Installing the Controller on page 15. For more information, see the Installation Guide for your controller. 2 Install the Storage Manager software and I2O driver from the Adaptec CD-ROM Autorun installation utility. If the Setup utility does not start automatically, select Start-Run and enter d:\autorun.exe, where d is the letter assigned to your CD-ROM drive. 3 If necessary, the Windows New Hardware Wizard will guide you through the rest of the process. Follow the instructions displayed. 24