Adaptec 2200200 Quick Installation Guide - Page 10

Installation Checklist, Before You Begin, Optional - drivers

Get Adaptec 2200200 PDF manuals and user guides View all Adaptec 2200200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Adaptec Storage Enclosure 335SAS ● 10 Installation Checklist To install the Adaptec 335SAS enclosure, complete these tasks: ❏ Work through the steps in Before You Begin (see page 10). ❏ Install disk drives into the enclosure (see page 11). ❏ Optional: Remove the fan (see page 12). ❏ Install the enclosure into your computer (see page 14). ❏ Connect the enclosure to a controller (see page 15). ❏ Connect the power cables and the LED or I2C cable (see page 18). Before You Begin Before you begin, complete these preinstallation tasks: 1 Install a SAS or SATA controller and device drivers into your computer. For instructions, refer to the controller's documentation. 2 Remove all components from the packaging and inspect them. Place on an antistatic surface until you are ready to use them. 3 If you are using new disk drives, follow the manufacturer's installation instructions. 4 Take appropriate safety precautions to protect yourself and your equipment. ! Caution: Before touching any of the enclosure components, ground yourself and take ESD precautions. Use an antistatic wrist strap and a grounding wire as a minimum precaution. You will need a Phillips screwdriver to complete the installation.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
Adaptec Storage Enclosure 335SAS
●
10
Installation Checklist
To install the Adaptec 335SAS enclosure, complete these tasks:
❏
Work through the steps in
Before You Begin
(see
page 10
).
❏
Install disk drives into the enclosure (see
page 11
).
❏
Optional:
Remove the fan (see
page 12
).
❏
Install the enclosure into your computer (see
page 14
).
❏
Connect the enclosure to a controller (see
page 15
).
❏
Connect the power cables and the LED or I2C cable (see
page 18
).
Before You Begin
Before you begin, complete these preinstallation tasks:
1
Install a SAS or SATA controller and device drivers into your
computer. For instructions, refer to the controller’s documentation.
2
Remove all components from the packaging and inspect them. Place
on an antistatic surface until you are ready to use them.
3
If you are using new disk drives, follow the manufacturer’s
installation instructions.
4
Take appropriate safety precautions to protect yourself and your
equipment.
Caution:
Before touching any of the enclosure components,
ground yourself and take ESD precautions. Use an antistatic
wrist strap and a grounding wire as a minimum precaution.
You will need a Phillips screwdriver to complete the installation.
!