Adaptec 2400A Installation Guide - Page 98
Create Driver, SMOR or Storage Manager.
![]() |
View all Adaptec 2400A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Controller Reset Procedures 4 When you see the Adaptec splash screen, click Create Driver Disk. Then, click the appropriate menu option. 5 Insert a floppy disk and click OK. The system creates the bootable SMOR disk. 6 Remove the Adaptec RAID Installation CD and the driver floppy disk. 7 Shut down the system. 8 If necessary, reinstall the controller in your system. Now, to reset the controller firmware, BIOS, and SMOR, perform the following tasks: 1 Install a jumper on flash mode 0 jumper connector. For the location of the jumper connector, refer to Appendix A. 2 Insert the SMOR boot disk and boot the system. SMOR starts. 3 Use SMOR to flash the controller firmware. 4 Shut down the system. 5 Remove the jumper you installed in Step 1. 6 Remove the SMOR boot disk. 7 Reboot the system from the SMOR boot disk. If the system restarts normally, the controller can now be configured using SMOR or Storage Manager. 8 Use SMOR to flash the controller BIOS and SMOR images. If the system fails to restart, call Adaptec Technical Support. D-3
![](/manual_guide/products/adaptec-2400a-installation-guide-cbaf807/98.png)