Adaptec AHA-2940U2 User Guide - Page 12

4 4 STEP 2 Connect the other end of the cable to a SCSI connector on the back of an external peripheral. If you are installing only one external peripheral, terminate the peripheral and skip to Step 4. SCSI Terminator (Not Included in Kit) STEP 3 Connect other external peripherals by connecting each peripheral to the previous one until all peripherals are connected. The peripheral at the end of the chain must be the only external peripheral terminated. Terminated SCSI Peripheral STEP 4 Connect all power cables to the external peripherals. INSTALLING SCSI CARD 2940U2W SOFTWARE To install the SCSI Card 2940U2W software (software driver), go to the section below for the operating system (for example, Windows® 95) installed on your computer. If the operating system is not yet installed, install it now. Refer to your operating system documentation for instructions. NOTE If you have installed a new SCSI hard drive in a computer running Windows or DOS, you must partition and format the drive with the DOS Fdisk and Format commands before it can be used. Refer to your Windows and DOS documentation for instructions. 12