Alesis MultiMix 6 FX Reference Manual - Page 23

A Tour of the MultiMix 2 EFFECTS LEVEL If you are using one of the MultiMix-6FX's internal effects, this knob controls the effect level. LED Meters These are the two rows of yellow, green and red lights you see in the master section of the mixer. They are very versatile, allowing you to view the signal level of the main mix and aux return depending on which signal you have routed to the control room mix. POWER Indicator When this LED is lit up, that means the POWER ON switch on the rear of the mixer has been activated. +48V Indicator When this one is lit up, that means the PHANTOM ON switch on the rear of the mixer has been activated and is supplying +48V phantom power to all XLR mic inputs. Rear of the Mixer Here's what you'll find at the rear of the mixer. POWER INPUT ON POWER OFF PHANTOM Power Input Here's where you plug in your mixer's external power supply. You should always connect your power supply to the mixer before you plug the power supply into an electrical outlet. Power Supply Unit This unit provides 18.5 VAC at 700 mA, more than enough to keep your MultiMix-6FX running smoothly. As with nearly all power supply units, this one tends to get warm when left on for a while. This is perfectly normal. Power On Another easy one. Switch this one on and your mixer has power. Switch it off and it doesn't. Make sure that all master output knobs are turned all the way down when powering your mixer up or down. The POWER INPUT is built to accept only the power supply unit provided with your MultiMix-6FX, or an AC power supply that has the same specs. Others probably will not work. 21