Alpine 7893 Owners Manual - Page 39
Installation
View all Alpine 7893 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installation Metal plate Caution Detachable Front panel When you install this unit in your car, do not remove the Detachable Front Panel. If the Detachable Front Panel is removed during installation, you might press too hard and warp the metal plate that holds it in place. 1 Mounting Sleeve (Included) Dashboard CDA-7995/CDA-7894/CDA-7893/CDA-7892 Slide the mounting sleeve into the dashboard. 2 Hex Nut (M5) Screw ∗∗ Bolt Stud Metal Mounting Strap ∗ Ground Lead Chassis CDA-7995/ CDA-7894/ CDA-7893/ CDA-7892 Reinforce the head unit with the metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis. NOTE ** For the screw marked , use an appropriate screw for the chosen mounting location. Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the CDA-7995/CDA-7894/CDA-7893/CDA-7892. Connect all other leads of the CDA-7995/CDA-7894/CDA7893/CDA-7892 according to details described in the CONNECTlONS section. 3 Lock Pin Slide the CDA-7995/CDA-7894/CDA-7893/CDA-7892 into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel. Removal 1 Remove the DETACHABLE FRONT PANEL. 2 Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin. 3 Pull the unit out, keeping it unlocked as you do so. Face Plate CDA-7995/ CDA-7894/ CDA-7893/ CDA-7892 Ground Lead ∗ Screws (M5 × 8) (Included) Mounting Bracket NOTE Secure the ground lead of the unit to a clean metal spot using a screw (∗) already attached to the vehicle's chassis. 37-EN