Alpine 9831 Owners Manual - Page 30

MobileHubTM Link Operation(Optional) SOURCE/ BAND/ POWER ►/11 TEL. TITLE ♦ SEARCH (21 • An outgoing callfmm a portable telephone is also possible. However, you cannot perform different operations at the same time from a portable telephone and CDA-9831/CDA-9830 as malfunction can result. • With a junction box connected outgoing, incoming, and sending history will also be recorded in the portable telephone. • While telephoning, defeat is set to ON. When the call hasfinished, the unit returns to your previous setting. • The telephone volume can be adjusted on the CDA-9831/CDA9830. The volume you set during the call is memorized, and is automatically applied again on the next call. • While telephoning or receiving incoming calls, press TITLE P to show the Network Operator display for 5 seconds. l IL It _IL 144 MENU NI Rotary encoder • F Preset buttons (1 through 6) About MobileHubTM Link Connect a separately sold junction box and a portable telephone (available from Nokia) to control the incoming and outgoing calls of the portable telephone. Caution Even with hands-free operation, a driver can be distracted during telephone operation or receiving a call. For the sake of safety, drivers are requested to refrainfrom operating the telephone while driving. For the sake of safety, only incoming calls and Speed-Dial outgoing calls can be operated. • If a portable telephone is connected, its address book, incoming and outgoing history are downloaded to the junction box. • Please refer to the instruction manual of the junction box. Telephone Mode ON/OFF Press and hold BAND/TEL. for at least 2 seconds to turn on the Telephone mode. To turn off, press BAND/TEL. See relevant pages for each item. • "NO PHONE" is displayedfor about 2 seconds, ifa portable telephone is not connected, before entering the telephone mode. Then the mode returns to the original source mode • When the portable telephone is taken off the junction box during an incoming or outgoing call, or during a hands-free call, the call will be treated as an ordinary one by the portable telephone. • When there is an incoming call while the power of CDA-9831/ CDA-9830 is off, the power of CDA-9831/CDA-9830 will turn on automaticallyfor a hands-free call. • Even if the power of the portable telephone is off, when CDA-9831/ CDA-9830 is set to Telephone mode, the power of the portable telephone will be turned on. • Even if the ACC power of the vehicle is turned off (even if the engine is stopped) during a hands-free call, the call is not disconnected, and an ordinary call by the portable telephone is possible. • If there is an incoming call during operation (except an outgoing call or talking), operation mode will end and switch to the incoming or talking mode. Incoming Calls 1 Press to receive an incoming call. 2 Press BAND/TEL. to finish a call. Telephone mode wilt end and return to the original source mode. • When the Automatic Calling mode is on, you can talk after 3 seconds of receiving the incoming call. (See "Setting the Automatic Calling" described below) Setting the Automatic Calling The incoming call can be switched to Automatic Calling or Manual Calling. 1 Press MENU to select the SETUP mode. 2 Select the TELEPHONE (TEL for CDA-9830) mode by pressing If -4 or 3 Turn the Rotary encoder to change to AUTO or MANUAL (MANU for CDA-9830). 4 Press MENU to select RETURN. The unit returns to normal mode. Pressing and holding MENU for at least 2 seconds will return to normal mode. • Press BAND/TEL. during an incoming call to disconnect it. • The initial setting of the factory is MANUAL. 28 -EN